







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Carrollton, TX: What It Costs and How Long It Takes
A chain link fence in Carrollton, TX runs $3,500 to $9,000 installed, and most residential lots land in three to five working days from layout to last tie. You’re pricing galvanized steel posts set in concrete, a tensioned mesh run, and at least one gate that swings clean. Call (844) 560-4467 and we’ll walk your property line with you and put a fixed number in writing.
How a Chain Link Fence Goes In, Start to Finish

Five stages. Each one has a decision on your side, and we don’t move to the next until it’s made.
Stage 1: On-site measure and utility locate (day 1, about 90 minutes)
We walk the line with you, mark corners, and confirm exactly where the fence sits relative to the property pins. Then we call in the locate for buried gas, water, electric and fiber. In Carrollton that step matters more than most people expect, because 1970s-era plats in 75006 and 75007 don’t always match what’s actually in the ground. You decide the fence line and gate locations before we cut anything.
Stage 2: Demo and layout (day 1, two to four hours on a replacement)
If there’s an old fence, it comes out now: posts pulled, concrete broken down below grade, hardware hauled off. Then we string the line, set grade, and confirm terminal posts at every corner, gate and end run. On a new build this stage is short. On a 30-year-old fence with root-bound posts it can eat a full afternoon.
Stage 3: Post setting and cure (day 1 into day 2)
Holes go to depth, posts get set plumb in concrete, and then the concrete needs to cure before it’s loaded with tension. This is the part that can’t be rushed. You choose post spacing here – 8 feet is standard, 10 feet saves a little on material and adds a little flex.
Stage 4: Framework and mesh (day 2 to 3)
Top rail, tension bands, brace rails on the terminal posts, then the mesh gets stretched and tied. A two-person crew hangs roughly 150 to 200 linear feet of residential chain link a day at this stage. You pick the mesh height and gauge before we order, not during install.
Stage 5: Gates, walk-through and punch list (day 3 to 5)
Gate frames hang last so they’re set against finished posts. We adjust the latch and swing, walk the whole run with you, and fix anything on the spot. Your decisions here are small – latch style, whether the gate swings in or out – but they’re the ones you’ll notice every day.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Fence Options You’ll Actually Choose Between
- Mesh gauge: 11.5 gauge is the light residential standard; 9 gauge is noticeably stiffer and adds roughly 15 to 25 percent to the mesh line of the quote. On a long run with dogs leaning on it, 9 gauge holds its shape.
- Height: 4 feet reads tidy in a front side yard, 5 feet is the residential default, 6 feet is what most people pick for a backyard. Going taller means bigger posts and deeper footings, so the price steps up more than the mesh does.
- Coating: Galvanized steel is the budget choice and will gray out over the years. Vinyl-clad mesh in black or green costs more up front and holds its color. If the fence is visible from the street, black vinyl-clad is usually the version homeowners regret not picking.
- Posts and top rail: 1 5/8 inch line posts with a 1 3/8 inch top rail is the common residential spec. Heavier pipe is worth it for a fence taking wind load across an open lot.
- Gates: A 4-foot walk gate or a 10 to 12-foot drive gate, single or double. Self-closing hinges and a drop rod on double gates are cheap adds that save a lot of annoyance.
- Privacy options: Slats woven into the mesh or a tensioned windscreen turn an open fence into a visual block. Slats darken the yard, cut wind, and add a noticeable line item.
We order from established domestic steel producers, and we’ll tell you plainly when the lighter gauge is genuinely fine and when it isn’t. Most jobs get finished in a single visit after the concrete cures.
What a Chain Link Fence Costs in Carrollton, TX

Residential chain link in Carrollton lands between $3,500 and $9,000 installed, gates and cleanup included. Here’s what separates a job at the low end from one at the high end.
| Line item | Typical range |
|---|---|
| 150 ft, 5 ft tall, galvanized, one walk gate | $3,500 – $4,800 |
| 200 ft, 6 ft tall, vinyl-clad, two gates | $5,500 – $7,500 |
| Drive gate, single or double, installed | $700 – $1,800 |
| Tear-out and haul-off of existing fence | $300 – $800 |
| Privacy slats or windscreen | $400 – $1,200 |
What pushes the number up: total linear feet and corner count, since every corner needs a braced terminal post; grade changes, which mean stepped or racked panels instead of a straight run; mesh height and gauge; how much old concrete has to come out; and whether the line crosses roots, irrigation, or an existing utility easement that forces a reroute.
What’s in a written estimate: posts, concrete, mesh, top rail, gates, hardware, tear-out where needed, and haul-off. What’s usually not: landscaping repair along the line, sprinkler reroutes, and anything the utility locate turns up. We spell all of that out before you sign, so the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Carrollton Homes Specifically Do to This Job
Carrollton’s building stock splits cleanly, and the fence side of it splits with it. In the older first-ring subdivisions off Josey Lane and Belt Line, the fences going in today are replacements. Those 1970s and 1980s lots have mature pecan and live oak root systems, and pulling old posts out of that ground is a different job than setting new ones in open soil. Expect the tear-out line item to run high on those properties.
Out in 75010, it’s the opposite – newer large-lot subdivisions where a chain link run is often the first enclosure on bare ground, and wind load across an open back line drives the post and footing spec. Slab-on-grade foundations and North Texas clay soils mean grade moves over time, so a fence set tight to the house today can show a gap in three years if the run isn’t given room to flex.
On the permit side, Carrollton requires a permit for new fence construction and checks height and setback limits at the property line, and HOA rules in the newer subdivisions routinely restrict visible fencing at the front corner. Expect permit review to take a bit longer on infill lots near the downtown and Belt Line redevelopment corridors than on straight residential remodels – we account for that in scheduling. We cover all of Carrollton, from 75006 through 75010, and we read the setback and height limits for your specific plat before quoting.
Serving Carrollton, TX – Our Local Coverage Area
We serve Carrollton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Chain Link Fence in Carrollton

Most residential jobs run three to five working days, and roughly half of that is concrete cure time. A short 100-foot run with one gate can wrap in two days; a 250-foot replacement with a drive gate and tear-out runs closer to the five-day side. Call (844) 560-4467 for a date range based on your lot.
Yes, Carrollton requires a permit for new fence construction, and the city checks height and setback limits at the property line. We pull the permit and schedule the inspection as part of the job, and we confirm the limits for your plat before we quote, since they vary by subdivision.
In most cases, yes – a good gate location and a slightly adjusted line route around the locate marks avoid the trenching entirely. When a sprinkler zone sits directly on the property line, we reroute the run and note the cost in the estimate instead of surprising you at install.
Plan on $3,500 to $9,000 for a typical residential run, with height, gauge, coating and gate count as the main levers. A basic 150-foot galvanized install with one walk gate sits near the bottom of that range; a taller vinyl-clad run with two gates and a drive gate lands near the top. Call (844) 560-4467 for an exact quote – estimates are free.
Every chain link fence we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, for two full years after the last post is set. Material warranties come from the steel manufacturer separately, and we hand those documents over at walk-through. If you’re adding a gate at the same time and want the whole entry rethought, homeowners often pair this with Door Installation in Carrollton.
Get a Fixed Chain Link Fence Quote in Carrollton
When you call (844) 560-4467, a live person answers – day, night, weekend – and books a free on-site estimate. We walk the line, call in the locate, and hand you a written line-item quote with the permit and the tear-out priced in. Most jobs are finished in a single visit once concrete cures, and every one is covered by the 730-Day Done Right Promise. If your fence line is part of a bigger plan, we can scope it alongside ADU Site Prep & Utilities in Carrollton or fold it into a full Fence Installation in Carrollton project.
Written by the team at Groundwork Construction Co.












