







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Addison, TX: What It Costs and How Fast It Goes In
A chain link fence in Addison, TX usually runs $3,500 to $9,000 installed, and most residential runs of 150 to 200 linear feet are finished in one to three days. You’re looking at a galvanized or vinyl-coated steel system on posts set in concrete, with gates, tension bands and top rail. Call (844) 560-4467 for a free on-site estimate and a written, line-item quote before anything gets ordered.
How a Chain Link Fence Goes In, Stage by Stage

Chain link is one of the few exterior jobs where the sequence is genuinely predictable. Here’s what actually happens, and where you’ll be asked to make a call.
Stage 1: On-site measure and layout (about an hour)
We walk the property line with you, confirm where the fence runs, and flag anything underground: irrigation lines, gas risers, the electric service to a detached structure. On a tight Addison lot, this is where we work out gate swing and clearance so a gate doesn’t foul a parking pad or an alley approach. You decide the run and where the gates go at this stage, not later.
Stage 2: Utility locate and permit (one to three business days)
Before a single post hole gets dug, the locate request goes in so nobody puts a digging bar through a buried line. If the job touches a property line dispute, an easement or a shared commercial boundary, that gets settled here. You sign off on the final layout.
Stage 3: Demo and post setting (day one)
Old fence comes out, holes get augured, and posts go in set in concrete. Standard residential posts are typically 2 3/8-inch line posts and 2 5/8-inch terminal posts at corners and gates, set roughly 24 to 36 inches deep depending on soil and frost line. Concrete needs to cure before tension goes on, so the fence does not get finished the same day the posts go in. That’s not a delay tactic; it’s how the fence stays tight for years.
Stage 4: Framing and fabric (day two or three)
Top rail, tension bands, brace bands and the chain link fabric itself go up, then gates get hung and adjusted. You walk the line with us and check gate swing, latch alignment and fabric tension before we call it done.
Stage 5: Final walkthrough and cleanup
We haul off the old material and leftover concrete spoils, and you get a walkthrough on what was installed and how the gate hardware adjusts. Any issue found here gets fixed before we leave the property.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
There’s more decision-making here than most homeowners expect. Here’s the honest trade-off on each.
- Galvanized steel, standard grade: the baseline. Cheapest per foot, holds up well in North Texas, and the zinc coating resists rust for years. The look is industrial, which is fine for a side yard or a back boundary and less fine for anything facing the street.
- Vinyl-coated steel: a bonded color coating over galvanized core, usually black or green. Costs more than bare galvanized but reads much cleaner against landscaping and, in a mostly commercial city like Addison, blends better where a residential fence sits next to a business frontage.
- Gauge of the fabric: an 11.5-gauge wire is the residential norm; 9-gauge is heavier and worth it if you’re securing a side yard against dogs or foot traffic. Ask which gauge is being quoted, because it’s the easiest place to get shortchanged.
- Height: 4-foot, 5-foot and 6-foot are the standard residential heights. Six-foot is the usual pick when the fence is doing security work rather than just marking a line.
- Gate type: walk gates with self-closing hinges for a side yard, or a double drive gate if you’re enclosing a parking area. Wider gates need heavier posts and a proper drop rod, which is a real cost item, not a throw-in.
- Post caps and top rail: small money, noticeable difference in how long the top of the fence lasts.
Belgard and Tremron both make hardscape and border products that pair well when a chain link run meets a patio edge or a parking apron, which comes up often on the small Addison lots where fence and paving run right into each other.
What a Chain Link Fence Costs in Addison, TX

The installed range for a residential chain link fence in Addison is $3,500 to $9,000. A basic 4-foot galvanized run on a small back boundary sits near the bottom; a 6-foot vinyl-coated perimeter with a drive gate and several walk gates pushes toward the top.
| Line item | Typical range |
|---|---|
| Standard 4-foot galvanized run | $3,500 – $5,500 |
| 6-foot vinyl-coated perimeter | $5,500 – $8,500 |
| Walk gate with self-closing hinge | $250 – $600 |
| Double drive gate with drop rod | $700 – $1,800 |
| Old fence removal and haul-off | $300 – $900 |
Five things push a job from the low end to the high end: total linear feet (the biggest driver by far), height and gauge, gate count and gate width, how much old fence has to come out, and site access. A tight Addison lot where material has to be hand-carried from a street-side drop point costs more in labor than a job where a truck can back right up to the run. Soil matters too; rocky or heavy clay ground slows post hole work.
A written estimate should spell out linear feet, post spacing, gauge, coating, gate count and hardware, concrete, and removal. What’s often left out by cheaper bids: spoil haul-off, gate hardware, and any allowance for chipping through existing concrete or pavers where a new post line crosses paving. Get those named in writing, since the number you see is the number you pay with us.
See the difference
Before
After
Before
After
Before
AfterWhat Addison Specifically Does to a Chain Link Job
Addison is a small, nearly built-out city of about 4.4 square miles, and most of it is commercial: restaurants, hotels, offices, and the airport. That shapes fencing work here in ways that don’t apply in a greenfield suburb. There’s very little traditional single-family housing. What does exist is older, and a good chunk of the multifamily and mixed stock dates to the 1970s through the 1990s. So a chain link job in Addison is very often a perimeter behind a business, a service-yard boundary, or a residential property line that runs up against a commercial neighbor.
Two practical consequences. First, on commercial and mixed parcels, the fence frequently shares a line with a property another owner controls, so layout gets finessed, not assumed. Second, because the city is hemmed in and fully developed, jobs happen on occupied sites: we schedule around operating businesses and parking, which means staging material in tight spots and getting in and out without blocking the alley or a drive-through lane. The North Texas heat and spring hail also matter; wind-driven hail dents and dulls older chain link fabric, and we regularly see fabric that’s structurally fine but visually shot after a few rough storm seasons. That’s a routine observation here, not a sales line.
We cover the whole city, including 75001, and the surrounding area, so if you’re on the edge of Addison, give us a call and we’ll confirm we can get to you. Fencing is also often one piece of a bigger exterior project, and it’s worth pairing with ADU Site Prep & Utilities in Addison if you’re adding a structure, or with Door Installation in Addison if a back entry needs an upgrade alongside the new run.
Serving Addison, TX – Our Local Coverage Area
We serve Addison and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Addison

Most residential chain link runs take one to three days on site, plus a short window for the utility locate beforehand. Post setting and fabric stretching are on different days because the concrete has to cure first. For a commercial or shared-boundary parcel, add time for layout sign-off. Call (844) 560-4467 to get a schedule estimate for your specific run.
It depends on the property type and the height, and the answer is different for a commercial tenant fence than for a residential property line. We confirm with the city what your run requires before we set posts, so you’re not stuck with a fence that has to come back out. Call (844) 560-4467 and we’ll walk you through what applies to your address.
In most cases, yes. Post holes are augured individually rather than trenching a continuous line, so the disruption is limited to the holes and a small work zone. The exception is where the new line crosses existing concrete or pavers, which needs a clean cut and a patch. We flag that at the estimate so there are no surprises. Call (844) 560-4467 for a free on-site look.
Expect $3,500 to $9,000 installed for a typical residential project, with the top of that range driven by linear feet, 6-foot vinyl-coated fabric, and multiple gates. A drive gate and old fence removal are the two line items that move the number most. Call (844) 560-4467 for an exact quote – estimates are free.
Our workmanship is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right. That covers installation quality like post alignment, fabric tension and gate hardware. Material warranties come from the manufacturer and vary by coating and gauge. Call (844) 560-4467 to talk through what your specific quote includes.
Get a Free Chain Link Fence Estimate in Addison
We’ll come out, measure the run, check for anything underground, and hand you a written line-item quote covering linear feet, gauge, coating, gates and removal. No pressure, no vague numbers. Our technicians have up to 12 years of experience, and calls are answered by a live person around the clock. Call (844) 560-4467 to schedule your free estimate. If you’re weighing the fencing against a larger exterior project, it’s also worth a look at our Fence Installation service, and if the chain link is part of a full property improvement, see Fence Installation in Addison.
Written by the team at Groundwork Construction Co.












