







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Highland Park, TX: What It Involves and What It Costs
A chain link fence in Highland Park typically runs $3,500 to $9,000 installed, and most residential runs are finished in one to three days once the layout and property line are confirmed. The job means setting posts, stretching mesh, hanging gates, and tying the run into existing lot lines. Call (844) 560-4467 and we’ll walk your lot and quote it on the spot, with a free written estimate.
How we build a chain link fence here, one stage at a time

No two lots in Highland Park are laid out the same, so the first hour is usually spent figuring out where the fence actually belongs before anyone digs.
Stage 1: Layout and property-line confirmation (about 1 – 2 hours)
We walk the run with you, mark gate locations, and confirm the line against your survey or plat. In this town, lot lines tend to be tight and often run right beside a neighbor’s fence or a protected tree. You decide the exact path, gate count, and whether the fence ties back into an existing structure or starts fresh. If the plat is unclear, we flag it before digging.
Stage 2: Locating buried lines before we dig (same day)
Every post hole gets cleared through the Texas 811 call-before-you-dig service, and we hand-check sprinkler lines and any shallow irrigation from the prior landscaping. Black-clay soil here shifts enough that old utility runs and drainage tile don’t always sit where the records say. You don’t need to do anything at this stage except tell us where your sprinkler controller shuts off.
Stage 3: Setting posts and concrete (day 1)
Posts go in at 6- to 10-foot spacing depending on height and wind exposure, set in concrete to below the active clay layer. This is the stage that decides whether the fence stays plumb after a wet spring, so it’s the one we don’t rush. Fence line posts typically go in over a single day; a large property may push into a second.
Stage 4: Stretching mesh, top rail, and tension (day 2)
We hang top rail and tension wire, stretch the mesh tight off the terminal posts, and cut to fit. Mesh that’s pulled loose will sag within a season on this soil, so the tensioning is a judgment call we make with you watching. Gates get hung with hinges and latches at your chosen height and swing direction.
Stage 5: Gate hardware, walkthrough, and cleanup (day 2 – 3)
Latches, drop rods, and any privacy slats or windscreen go on last. We sweep debris, pull the stakes, and walk the whole run with you so the fence, gate, and gates line up to your expectation. Anything off the mark gets corrected before we leave. That’s the 730-Day Done Right Promise: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
Chain link is a commodity product, but the spec you pick changes both the price and how long the fence holds up in Highland Park’s soil and weather.
- Gauge of mesh: 11.5-gauge (standard) costs less and suits a perimeter or pet run; 9-gauge (heavier) runs more per linear foot but resists dents and tightening failures on long runs. For anything that has to last decades, we lean toward the heavier mesh.
- Height and wind rating: 4-foot is typical for property lines; 5- and 6-foot runs cost more in posts, concrete, and top rail. Higher fences catch more wind, so post density matters.
- Coating: galvanized (the cheapest, gray) versus color-coated vinyl over galvanized in black, green, or brown. The coated line reads softer against a stucco or brick wall and holds its color.
- Gate type: a single walk gate, a double drive gate on the alley side, or a self-closing pool-compliant gate. Swing hardware and latch grade drive a meaningful share of the gate cost.
- Toppers and slats: privacy slats (for a more private yard), tension wire, or barbed top on commercial runs. Each is a line item, not an assumption.
Ground conditions also count: if buried clay is soft or your line has to cross a drainage swale, posts get an engineered concrete collar, which shows up as a small add to the estimate.
What a chain link fence costs in Highland Park, TX

Plan on $3,500 to $9,000 for a typical residential chain link fence in Highland Park, with most of that spread landing in the $5,000 – $7,000 range on a standard half-lot perimeter. Here’s what moves the number:
- Linear footage: the largest driver. A quarter-acre yard runs less than a full corner lot; every extra 100 feet adds real cost in mesh, post, and concrete.
- Gauge and coating: upgrading from 11.5- to 9-gauge mesh or adding color coating adds a per-foot premium.
- Gate count and type: drive gates on the alley side, double gates, or self-closing hardware can swing hundreds of dollars each.
- Terrain and removal: pulling out an old fence, cutting through a concrete mow strip, or working around protected trees adds labor and can push a job toward the high end.
- Permit scope: Highland Park’s own inspection department may require a permit for fences over a certain height or in a front setback, and the permit fee and inspection add to the total.
A written estimate from us lists the footage, gauge, coating, gate details, footing spec, permits, and cleanup as line items. What’s usually not included: landscape repair beyond reseeding, moving utility lines, or grade work. We call those out upfront so there are no change orders. Upfront pricing, no surprises.
See the difference
Before
After
Before
After
Before
AfterWhat Highland Park homes do to this job
Almost nothing here is a clean-slate clearing. Highland Park is essentially built out, under its own design review and a strict tree ordinance, so a fence project may stall on a protected live oak’s root zone or a setback question before a post goes in. Contractors must thread the town’s design-review and Historical Review Board process along with lot lines that run tight to neighbors on streets like Beverly Drive and Lakeside. The housing stock is largely 1910s – 1930s, and because the older homes sit on pier-and-beam foundations, the front fence often hides a pier line, irrigation trench, or an old lead water service that doesn’t appear on any plat. The black-clay soil under it all swells and shrinks with the wet-dry cycle, so a fence set at shallow depth can heave the following spring. The failure we see most is a builder-era fence with undersized posts and loose mesh that leans after two wet seasons. Inspections here are handled by Highland Park’s own department, not Dallas’s, so the permit path and timing look different than a job a few blocks away.
This is also the kind of project that rarely stands alone: homeowners often pair a new perimeter fence with Fence Installation in Highland Park upgrades, or fold it into Fence Installation work across the yard when they’re already touching the back lot. If a detached structure or garage is on the drawing board, we’ve handled ADU Site Prep & Utilities in Highland Park alongside the fence run, and a new gate or entry often pairs with Door Installation in Highland Park. We cover the whole town, including the blocks near Highland Park proper, and the close-in neighborhoods around University Park, Farmers Branch, and Addison.
Serving Highland Park, TX – Our Local Coverage Area
We serve Highland Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Chain Link Fence in Highland Park

Most residential chain link fences in Highland Park go in over one to three days from post-setting to final walkthrough, weather and line-location permitting. A short pet run may finish in a single day; a full corner-lot perimeter with drive gates usually spreads to three. Call (844) 560-4467 for a schedule estimate built around your lot.
Often yes, depending on fence height and setback, and Highland Park runs its own building inspection department separate from Dallas. We confirm what the height and location on your lot require before we dig and build the permit into the written estimate. Call (844) 560-4467 and we’ll tell you what your specific line needs.
Usually yes. Post holes are dug individually, not trenched, so mature trees and established beds can stay in place when the layout allows. In Highland Park, protected tree root zones sometimes require the line to shift a few feet, and we’ll flag that before digging rather than after. Call (844) 560-4467 to walk the lot.
A typical residential chain link fence in Highland Park runs $3,500 to $9,000 installed. The number depends on linear footage, mesh gauge, coating, gate count, old-fence removal, and permit scope; a corner lot with drive gates will land toward the high end. Call (844) 560-4467 for an exact quote. Estimates are free.
Every chain link fence we build is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in the residential space; if it’s not done right, we make it right. That covers the installation, not damage from storms or a car backing into a gate. Call (844) 560-4467 to hear the coverage details on your job.
Get a free chain link fence estimate in Highland Park
Call (844) 560-4467 for a free on-site estimate on your chain link fence in Highland Park. A live person answers day or night, and the call takes about ten minutes: we confirm your lot size and rough footage, talk through gauge, height, and gates, and set a time to walk the property. You’ll get a written, line-item quote with the permit path spelled out. The number you see is the number you pay.
Written by the team at Groundwork Construction Co.












