







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
An exterior door installation in Lewisville usually runs $650 to $2,400 per door, depending on whether we’re setting a new prehung unit into an existing opening or cutting a fresh one through brick. A standard exterior door swap is a one-day job. A new opening in a brick ranch, or a set of workshop doors on an acreage property, runs two to three days. Call (844) 560-4467 and we’ll walk through the scope before anyone comes out.
How Door Installation Actually Runs, Step by Step
Every door we set follows the same order, because skipping a step is how a door ends up sticking in August and whistling in January. Here’s what the four stages look like in real time.
Stage 1: Measure and decide (before the crew arrives)
We measure the rough opening, check the existing frame for square and rot, and confirm the swing direction and handing. This is when you pick the material, the glass package if there is one, and the finish. On older pier-and-beam homes in Old Town, we also check how the floor plane sits relative to the threshold, because a door that’s level to a sagging subfloor will drag. Figure 30 to 45 minutes on site, and the decisions happen here, not mid-install.
Stage 2: Demo and prep (day one, morning)
The old door and trim come out, and the rough opening gets cleaned down to framing. On brick exteriors we cut back the brick mold carefully so it can be reused or matched. Any rotted jack stud or sill plate gets replaced before anything new goes in. This stage takes two to four hours for a standard door and most of a day if we’re cutting a brand-new opening through masonry.
Stage 3: Set, shim, and seal (day one, afternoon)
The unit goes in plumb, level, and square, shimmed at the hinges and the strike, then fastened through the frame. We flash the exterior and set the threshold in a continuous bead of sealant. This is where a cheap install shows up a year later as a rotten sill, so it gets the time it deserves. Two to three hours.
Stage 4: Trim, hardware, and walkthrough
Casing goes on, the lockset and deadbolt get fitted and aligned, weatherstripping is checked across the full perimeter, and we open and close the door a dozen times to confirm the swing. You get a walkthrough of the seal, the hardware, and the finish. Another two hours on a typical door.
For oversized or heavy-duty doors on a detached workshop, plan on a longer timeline. Those units are heavier, the openings are taller, and the hardware is commercial-grade, so we allot a full extra day. Most jobs are completed in a single visit; the big ones get the time they need, done right in one trip.
The Door Options You’ll Choose Between

This is the part buyers spend the most time on, and it’s where the honest trade-offs matter. Here’s how the main choices shake out.
- Fiberglass entry doors: the best all-around pick for North Texas. They hold up to summer heat and hail without denting, come in wood-grain textures that read as real, and won’t rot at the sill the way wood does. Mid-range cost, excellent long-term value.
- Steel doors: strongest on security and the cheapest of the three, but they can dent under impact and a scratched finish invites rust. Fine for a back door or a garage-to-house entry, less ideal for a showpiece front.
- Wood doors: the premium look, and the one that needs the most from you. Beautiful on a restored Old Town ranch, but wood moves with the wet-dry swing here, so it needs a good finish and occasional attention.
- Glass and finish: a full-lite or decorative glass panel adds $200 to $900 depending on the pattern, and low-E glass helps with the summer sun load. Paint-grade versus stain-grade trim changes the price and the maintenance math.
- Hardware and handing: a standard lockset is quick work; a smart lock or multi-point system takes longer to align and costs more. Confirm the swing direction and handing before the order goes out, not after.
We stock and install doors from brands like CertainTeed and Owens Corning for the exterior envelope, and we’ll steer you toward units built for the local climate rather than whatever’s on a clearance rack. If your door project is part of a full Windows & Doors in Lewisville upgrade, the door spec should line up with the window package so the whole elevation looks intentional.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What Door Installation Costs in Lewisville, TX
Most exterior door installation in Lewisville lands between $650 and $2,400 per door. The low end is a standard prehung swap into a sound existing opening. The high end is a new opening through brick, a heavy workshop door, or a premium unit with decorative glass. Here’s how the line items break down.
| Item | Typical range |
|---|---|
| Standard exterior door swap (existing opening) | $650 – $1,200 |
| New opening through brick or siding | $1,200 – $2,400 |
| Premium glass or decorative panel | $200 – $900 add |
| Heavy workshop or oversized door | $1,500 – $3,500 |
| Hardware and smart lock upgrade | $100 – $500 |
The variables that push a job to the high end: cutting a fresh opening (framing and header work), the condition of the existing frame (rot means new framing), material grade, and whether the door is part of a larger scope that pulls a permit. What’s included in our written estimate: demo, framing repair, the door unit, flashing and sealant, trim, hardware install, and cleanup. What’s not: painting or staining the new door, and anything you add after the quote is signed.
You get upfront pricing, no surprises. The number on the written estimate is the number you pay. Projects over $10,000 qualify for $1,000 off, with 0% financing for 18 months available, and all work is covered by our 730-Day Done Right Promise. If it’s not done right, we make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Lewisville Homes Specifically Do to This Job

Lewisville is a two-speed market, and it shows up at the threshold. In Old Town and the older core near the lake, we’re replacing doors on 1960s to 1980s brick ranch and pier-and-beam homes where the black gumbo clay has done its slow work for decades. Foundation movement is a real factor here: as slabs and pier-and-beam floors shift through the wet-dry cycles, door frames rack out of square, and a door that closed fine in the spring won’t latch in August. When you’re replacing a road-facing door, plan on framing correction as part of the job, not an add-on.
Up north, the newer subdivisions in the growth zones are a different animal. Brand-new construction means tight, square openings and straightforward swaps, but the lake-adjacent and floodplain-adjacent corridors near the Elm Fork add elevation and permitting considerations, so a door in those spots deserves a quick check on the applicable rules before we order. HOA guidelines are a real factor on exterior color and door style in the newer tracts, and it’s worth reading yours before you fall in love with a finish. Whether you’re covering Lewisville near the lake, the northern growth zones, or the older core, we’ve worked the range of them.
Serving Lewisville, TX – Our Local Coverage Area
We serve Lewisville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Lewisville
A standard exterior door swap takes one day, start to finish. A brand-new opening through brick, or an oversized workshop door, runs two to three days. Call (844) 560-4467 for an exact timeframe once we’ve seen the opening.
A like-for-like door replacement in an existing opening typically doesn’t require a permit, but cutting a new opening or changing the structure can. We confirm what your scope needs and pull the permits where required so the work passes inspection. Call (844) 560-4467 and we’ll clarify it for your project.
In most cases, yes. A replacement goes into the existing opening with no plumbing or structural changes. New openings near a bathroom or load-bearing wall are the exception, and we’ll map those out on the estimate. Call (844) 560-4467 to talk through your layout.
Exterior door installation in Lewisville runs $650 to $2,400 per door for standard work, and more for oversized workshop doors or new openings through brick. Call (844) 560-4467 for an exact quote, estimates are free.
Labor is backed by our 730-Day Done Right Promise. If a door we set fails to close, seal, or align, we make it right. The door unit itself carries the manufacturer’s warranty. Call (844) 560-4467 with any warranty question.
Pairing a door upgrade with other work is common – homeowners often add Cabinets & Countertops in Lewisville or plan a Garage Conversion ADU in Lewisville and want the entry and exterior to match. For the wider scope, see our Windows & Doors service.
Get a Free Door Installation Estimate in Lewisville

Call (844) 560-4467 to schedule a free on-site estimate for door installation in Lewisville. A live person answers around the clock, so you’re never stuck in a voicemail. We measure the opening, confirm the material and handing, and hand you a written line-item quote with upfront pricing, no surprises. Projects over $10,000 get $1,000 off, with 0% financing for 18 months available.
Written by the team at Groundwork Construction Co.












