







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in The Colony, TX: What It Costs and How Long It Takes
Door installation in The Colony typically runs $650 to $3,200 per exterior door installed, and most single-door jobs are finished in one day. Interior doors land lower, usually $350 to $950 each depending on slab, frame and hardware. The number that matters most here isn’t the door itself; it’s the wind rating and the flashing detail behind it, because a door that isn’t rated and sealed for North Texas storm season will leak or rack within a few years. Call (844) 560-4467 for a free on-site estimate and a written, line-item quote.
How a Door Installation Actually Runs, Start to Finish

We don’t hand you a schedule and disappear. Here’s the real sequence, with the decisions you’ll make and when you’ll make them.
Stage 1: Measure and site check (day 1, about 60 – 90 minutes)
We measure the rough opening, check the frame for plumb and square, and look at what’s behind the trim: sheathing condition, any old rot, and whether the existing threshold has been letting water in. On The Colony’s 1970s – 90s brick-veneer homes, we regularly find swollen subfloor at the back door from years of splash and poor flashing. You’ll get a written scope the same week, with the door spec and the price locked in.
Stage 2: Door selection and order (days 2 – 10, lead time varies)
You pick the material, the rating and the hardware. In-stock steel and fiberglass doors can be ready in a few days; a custom-sized or impact-rated unit may take three to six weeks. This is the stage where you decide whether you’re replacing the door in the existing frame or replacing the whole unit, and that choice changes both the price and the storm performance.
Stage 3: Demo and prep (installation day, 1 – 2 hours)
We pull the old door and trim, inspect the rough opening, and repair any rot or framing damage before anything new goes in. Flashing and sill pan go down first. This is the part nobody sees and the part that determines whether the door stays dry for the next twenty years.
Stage 4: Set, shim and seal (installation day, 2 – 4 hours)
The new unit gets set plumb and square, shimmed at the hinges and lock side, fastened per the manufacturer’s schedule, and sealed with the right flashing tape and exterior sealant. Hardware, lockset and strike plate get aligned so the door latches with a light push, not a shoulder.
Stage 5: Trim, finish and walkthrough (installation day, 1 – 2 hours)
Interior and exterior trim go back on, caulk lines get cleaned up, and we walk the door with you: swing, latch, weatherstrip contact, and the seal at the threshold. Most single-door jobs wrap in a single visit. Multi-door jobs, like a front entry plus a back patio door, usually take two days.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Door selection is where most of the price spread lives. Here’s the honest trade-off on each.
- Steel entry doors: The most common choice in The Colony. Strong, secure, and the lowest cost of the exterior options. They dent under impact and can rust at the bottom edge if water sits, so the threshold detail matters.
- Fiberglass entry doors: Won’t dent or rust, holds paint and stain well, and takes a wood-grain look. Costs more than steel but holds up better against hail and heat cycling.
- Wood entry doors: Beautiful and heavy, but North Texas sun and humidity demand regular refinishing. Suited to covered entries, not full-sun exposures.
- Impact-rated and wind-rated units: The right call for storm resilience. These carry a design pressure rating that matches local wind-load requirements. They cost 20 – 40% more than a standard door and are worth it on exposed elevations.
- Frame-in vs. frame-out: A frame-in replacement keeps the existing jamb and is faster and cheaper. A full unit replacement lets us fix rot and flashing properly, which is what most 40-year-old homes actually need.
- Interior doors: Hollow-core for closets and budget rooms; solid-core for bedrooms and bathrooms where sound and feel matter. Pre-hung vs. slab is a labor question more than a material one.
What Door Installation Costs in The Colony, TX

Exterior door installation in The Colony runs $650 to $3,200 per door, all-in. Interior doors run $350 to $950 each. Here’s what moves a job from the low end to the high end:
- Door material and rating: A standard steel door sits near the bottom. A fiberglass or impact-rated unit pushes toward the top.
- Frame condition: Rot, settling, or a rough opening that’s out of square adds carpentry time and repair scope.
- Frame-in vs. full unit: Full unit replacement costs more but fixes the flashing and sill, which is often the real problem.
- Hardware and finish: Standard lockset vs. a keyed handle set, plus trim and paint, add to the total.
- Permit and inspection scope: Structural changes or egress-related door swaps trigger permits and inspection, which adds time and cost.
A written estimate from us lists the door spec, the labor, the flashing and sealant, trim, and disposal line by line. It does not include structural reframing, drywall repair beyond the trim line, or painting, unless we quote those separately. Upfront pricing means the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat The Colony Homes Specifically Do to This Job
The Colony is a fully built-out, landlocked city on the south shore of Lewisville Lake, so almost every door job here is a replacement on an existing home, not new construction. Our core housing stock is 1970s – 90s brick-veneer ranch and traditional two-story homes, and many of those lake-adjacent subdivisions are hitting 40+ years old at the same time. That means we see whole streets replacing exterior doors in the same season. Spring hail and high-wind storms are the seasonal driver: a door that’s lost its weatherstrip contact or whose threshold has pulled away from the sill becomes a wind-driven rain entry point fast. Clay soil movement shows up too, racking frames enough that a door that used to latch now sticks. Because The Colony is essentially done growing, the work is almost all updating what’s already here, and that shapes the scope. When the door swap is part of a full Windows & Doors in The Colony project, we sequence it so flashing and trim are done once, not twice. Permits and inspections follow local wind-rating requirements for exterior openings, and we pull them where the scope requires it. If you’re in The Colony and thinking about a wider envelope update, our Windows & Doors service covers the rest of the home, and homeowners often pair a door replacement with Cabinets & Countertops in The Colony in the same remodel window. We also handle Garage Conversion ADU in The Colony when a new exterior door is part of converting the garage. To see how we cover the rest of The Colony, our service-area page lays it out.
Serving The Colony, TX – Our Local Coverage Area
We serve The Colony and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in The Colony

Most single-door installations take one day, roughly four to seven hours from demo to walkthrough. Multi-door jobs, or a door that requires frame repair or a permit, usually run two days. Call (844) 560-4467 for an exact timeline on your door.
A straight like-for-like door replacement typically doesn’t require a permit, but swapping to an impact-rated or wind-rated unit, changing the opening size, or adding an exterior door where there wasn’t one often does. We check the requirement for your specific address before we order, and we pull permits where the scope requires it. Call (844) 560-4467 and we’ll tell you what your job needs.
Yes, in most cases. A frame-in replacement leaves the wall, plumbing and framing untouched. If the opening itself has to change or the frame has rotted, we scope that as separate carpentry, tell you up front, and price it in the written estimate before any work starts. Call (844) 560-4467 to walk through your door.
Exterior doors run $650 to $3,200 installed, and interior doors run $350 to $950 each, depending on material, rating, frame condition and whether it’s a frame-in or full unit replacement. Call (844) 560-4467 for a free estimate with a line-item quote.
Our installation is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right. That covers the workmanship on the install, the flashing and the seal, not just the door itself. Call (844) 560-4467 to schedule your free estimate.
Schedule Your Free Door Estimate in The Colony
If you’re in The Colony and your entry door is letting in air, water, or worry, start with a free on-site estimate. Call (844) 560-4467 and a live person answers any hour, any day. We’ll measure the opening, check the frame and flashing, and hand you a written, line-item quote with a fixed price. Every install is background-checked, uniformed, and backed by the 730-Day Done Right Promise. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off. Built to last, backed in writing.
Written by the team at Groundwork Construction Co.












