







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in University Park, TX: What You’re Actually Getting Into
Paver driveway installation in University Park, TX runs $7,000 – $18,000 for most homes, and a typical job takes five to eight working days from demolition to the first drive. That range covers excavation of the old surface, a compacted crushed-stone base sized for North Texas clay, edge restraint, bedding sand, and the pavers themselves. Call (844) 560-4467 for a free on-site estimate.
How a Paver Driveway Gets Built Here, Stage by Stage
The work breaks into five stages, and you’ll make a decision at each one. The sequence matters more than the schedule because skipping a step on blackland clay is how driveways fail in three years.
- Stage 1 – Site walk and layout (day 1). We mark the driveway edges, confirm the slope away from the garage, and locate the water main, irrigation lines and any old utility trenches. On a University Park lot, this is also where we figure out where the dumpster sits and how a skid steer gets in past the trees. You approve the final layout before anything gets broken.
- Stage 2 – Demolition and haul-off (days 1 – 2). The existing concrete or asphalt comes out, along with enough subgrade to reach stable soil. On older properties we sometimes find an old driveway poured over a previous one; that second layer gets removed too, because pavers need to sit on a properly compacted base, not on rubble.
- Stage 3 – Base and compaction (days 2 – 4). This is the stage that decides whether your driveway lasts. We bring in graded crushed stone in lifts, wetting and compacting each one, then check the slope with a level. Expect a base depth of roughly 6 to 8 inches depending on what the soil tells us. You’ll want to see this step; it’s the one most homeowners never think to ask about.
- Stage 4 – Edge restraint, bedding and pavers (days 4 – 7). A concrete or spiked edge restraint locks the field in place, a thin bedding layer goes down, and the pavers get set in your chosen pattern. Herringbone holds traffic loads best for a driveway; running bond costs less in labor. This is where your material and pattern decisions show up.
- Stage 5 – Joint sand, compaction and cleanup (day 7 – 8). Polymeric joint sand gets swept in and the field is plate-compacted one more time. We walk the finished driveway with you, note any touch-ups, and leave a small quantity of spare pavers for future repairs.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Your Paver Driveway
- Concrete pavers vs. clay brick pavers. Concrete pavers from Belgard or Tremron are the workhorse choice: dense, uniform, available in dozens of shapes and colors, and the lower end of the price band. Clay brick costs more and behaves differently in freeze-thaw, but it’s the authentic match for the Tudor and Colonial revival homes throughout University Park.
- Pattern. Herringbone and 45-degree herringbone interlock and resist tire turning, which is why they’re standard for driveways. Running bond and basketweave look cleaner and cost less to install.
- Finish and texture. Standard tumbled pavers have a slightly irregular, older look; smooth or polished finishes read more contemporary. Permeable pavers with wider joints and an open-graded base let water through, which matters on tight lots where runoff has nowhere to go.
- Border and accent band. A contrasting soldier course around the perimeter adds curb definition for a relatively small material upcharge and a modest labor bump; it can also be used to widen the visual apron at the street.
- Matching walkway or apron. Homeowners often pair the driveway with a front walk of the same field material to tie the elevation together; that’s a separate scope item you can price at the same visit.
What Paver Driveways Cost in University Park, TX

Plan on $7,000 – $18,000 for a paver driveway in University Park. Five variables push a job toward the top or bottom of that band:
| Factor | Effect on Price |
|---|---|
| Driveway size (single vs. double, rear alley apron) | $2,500 – $5,000 swing |
| Existing surface and base condition | $1,000 – $3,500 if old base must be removed or subgrade repaired |
| Paver material (concrete vs. clay brick, premium lines like Techo-Bloc) | $1,500 – $4,000 |
| Access and staging (tree protection, narrow lot, crane or small equipment) | $500 – $2,500 |
| Drainage work (permeable system, regrading, French drain connection) | $800 – $3,000 |
A written estimate should spell out the base depth, the paver line and pattern, edge restraint type, joint sand, haul-off, and cleanup. What it typically does not cover: relocating sprinkler heads or gas lines that run through the driveway footprint, repairing a foundation issue discovered at excavation, or city tree-protection measures if a protected specimen sits on the property line. The 730-Day Done Right Promise applies to the workmanship, and pricing is fixed before we start; the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat University Park Homes Specifically Do to a Paver Driveway Job
University Park is a built-out, landlocked enclave of roughly 23,000 people, and nearly every project here is either a teardown-rebuild or a gut renovation on a tight lot. That changes the driveway job in ways that don’t show up in Highland Park or Richardson. Lots are often just 50 to 60 feet wide, the original housing stock dates to the 1920s – 1950s, and mature pecan and live oak canopies complicate equipment access and excavation. City of University Park permitting, lot-coverage rules and tree ordinances govern where a dumpster can sit and how close equipment can get to a protected tree, so staging and even the pour schedule are planned around HPISD drop-off congestion on streets like Beverly and Preston. Blackland clay soil expands and contracts with our wet-dry cycles, which is why base depth and compaction matter more here than they do on sand or loam; we size the base and drainage for it on every job. And because the rear garages are alley-fed, we frequently build the driveway to run from the alley apron, not just from the street. If your driveway is part of a Driveway & Pavers in University Park plan that also touches the front walk or a patio, we scope it all in one estimate.
Serving University Park, TX – Our Local Coverage Area
We serve University Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in University Park

Most paver driveways in University Park take five to eight working days, with the base-compaction stage eating the most time. Weather and permit inspections can add a day or two, especially during the spring hail season. Call (844) 560-4467 to schedule a free estimate and get a date range for your specific lot.
Yes, most paver driveway work in University Park requires a city permit, and the rules are governed by the City of University Park’s own permitting standards rather than a neighboring city’s. We pull the permit and manage the inspection as part of the job. Call (844) 560-4467 and we’ll walk through what your specific project needs.
No, not as a proper paver driveway. Pavers need a compacted crushed-stone base, and the existing concrete has to come out first; installing over a slab leads to settling and cracking within a few seasons. The estimate covers the full demolition and base build. Call (844) 560-4467 to schedule your free on-site assessment.
Clay brick pavers typically run $2,000 – $4,000 higher than concrete pavers on a standard University Park driveway, depending on size and pattern. Concrete pavers from Belgard or Tremron sit at the lower end; clay brick is worth the upcharge if you’re matching an older Tudor or Colonial facade. Call (844) 560-4467 for an exact quote, and estimates are free.
The 730-Day Done Right Promise: if anything we install isn’t right, we make it right, for two full years after completion. That covers workmanship, base and installation, while the pavers themselves carry the manufacturer’s warranty. Calls are answered by a live person, 24/7, and the local pro we connect you with is licensed and insured as Texas requires. Call (844) 560-4467 to get started.
Get a Free Paver Driveway Estimate in University Park
If you’re weighing a paver driveway for a University Park property, start with a free on-site estimate. Call (844) 560-4467; a live person answers around the clock, so you don’t land in voicemail. We’ll walk the lot, check the base and drainage, and hand you a written, line-item price before anything starts. Many of our University Park clients also pair the driveway with Door Installation in University Park or Cabinets & Countertops in University Park during the same visit. For the full scope of our Driveway & Pavers work, or to confirm we cover University Park and nearby neighborhoods, just ask on the call.
Written by the team at Groundwork Construction Co.












