







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Frisco, TX: What It Costs and How the Job Runs
A chain link fence in Frisco, TX typically runs $3,500 – $9,000 for a standard residential lot, and a straightforward run is usually a two- to three-day job once the layout is staked and the line is located. That range covers galvanized or vinyl-coated chain link with posts, top rail, tension wire, and a gate or two on a typical Frisco subdivision lot. The number that matters most is the one on your written estimate, so call (844) 560-4467 and we’ll walk your property, confirm the layout, and put real pricing in front of you before you commit to anything.
Key takeaways:
- Most Frisco chain link jobs land between $3,500 and $9,000 depending on linear feet, height, coating, and gate count.
- Your HOA architectural review usually takes longer than the install itself, so start that paperwork first.
- We handle ARB-compliant repairs and matching panels so a fix doesn’t trigger a violation.
- Line locates are mandatory before we dig a single post hole.
How we actually build a chain link fence here, stage by stage

Every job starts with a site walk. We measure the actual run in linear feet, check the grade, identify where the fence meets a neighbor’s line, and photograph the property so the layout is documented. This is also when you tell us the height (4, 5, or 6 feet), the coating, and how many gates you want. That conversation usually takes 30 to 45 minutes on site, and it’s the stage where most surprises get caught early.
Next comes the part people underestimate: the HOA architectural review and the utility locate. In Frisco’s master-planned subdivisions, the architectural review board has to approve the layout, height, and any visible material before a shovel goes in the ground. We prepare the submittal packet with the plot plan and specs, but the clock is on your board’s review timeline, which can run a week or several depending on the community. In parallel, we call in the 811 locate so no one hits an irrigation line, a gas service, or a buried conduit. Nothing gets dug until both clear.
Day one on site is layout and set. We string the line, mark every post at the correct spacing, then auger or hand-dig the holes to depth. Posts go in, get plumbed, and the concrete goes around them. This stage is weather-dependent because the concrete needs to cure before we load the fence, so on a larger lot it can spill into a second day.
Day two or three is the build-out. We hang the top rail and tension wire, stretch the fabric, tie it off, and set the gate posts and hardware. Terminal posts at corners and gates get braced so the fence holds tension through the seasons. Then we walk the line with you and adjust anything that’s off before we call it done.
The final stage is cleanup and the walkthrough. Spoils get hauled, the trench line gets raked, and we hand over the fence with the gate swing and latch tension checked in front of you. Everything we install is covered by our 730-Day Done Right Promise – if it’s not right, we make it right, and that’s in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between on a chain link fence
Chain link isn’t one product. The decisions you make at the estimate stage change both the price and how the fence holds up in North Texas weather.
- Galvanized vs. vinyl-coated fabric. Standard galvanized is the lowest-cost option and holds up fine, but it goes dull gray over time. Vinyl-coated (usually black or green) costs more up front and looks sharper against Frisco’s brick-and-stone homes, and the coating adds a layer of corrosion protection.
- Gauge and height. Residential fabric usually runs 11.5 or 12 gauge. Heavier gauge resists bending and dog damage but adds cost. A 4-foot fence suits a side-yard enclosure; 6-foot is the standard for backyard containment and pool-code compliance.
- Post type. Round posts are standard. Square posts are a visual upgrade that some HOAs prefer because they read cleaner from the street. Terminal and gate posts need to be heavier than line posts regardless.
- Gate count and style. Every gate adds a frame, hinges, a latch, and bracing. A walk gate and a drive gate change the post schedule. Some communities want a specific gate style or color, which we confirm before ordering.
- Tension wire and top rail. A taut, top-rail-and-tension-wire build keeps the fabric from sagging and is the difference between a fence that looks sharp for years and one that ripples after two summers.
If the chain link is part of a bigger yard or exterior project, it usually gets planned alongside our Fence Installation work, and homeowners often pair this with Door Installation in Frisco when they’re refreshing the gate side of the house at the same time.
What a Chain Link Fence costs in Frisco, TX

Residential chain link in Frisco lands in the $3,500 – $9,000 band. A small side-yard enclosure sits near the bottom. A full property perimeter with two gates, heavier gauge, and a vinyl coating pushes toward the top.
| Line item | Typical range |
|---|---|
| Standard 4-foot galvanized chain link, per linear foot | $18 – $28 |
| 6-foot vinyl-coated chain link, per linear foot | $25 – $40 |
| Walk gate with frame and hardware | $250 – $550 |
| Drive gate, single | $600 – $1,200 |
| Removal of an existing fence | $300 – $900 |
Five things move the number. Linear feet is the biggest driver. Height and gauge come next – stepping from 4 to 6 feet and going heavier adds cost per foot. Coating adds a premium over bare galvanized. Gate count and width push it up fast because each gate means heavier posts and hardware. And site conditions matter: rocky soil, tight lot lines, an existing fence to tear out, or a run that needs grading all add labor.
A written estimate from us lists linear feet, height, gauge, coating, post spacing, gate count, removal, and the line-locate call – line by line, so you see exactly what you’re paying for. It doesn’t cover HOA review fees, which your community sets, or any utility relocation a locate uncovers. Upfront pricing means the number on the estimate is the number you pay, with no change orders tacked on after the crew starts.
See the difference
Before
After
Before
After
Before
AfterWhat Frisco homes specifically do to this job
Frisco is one of the fastest-growing large cities in the country, and almost all of its housing went up after 1990. That changes what a chain link fence job looks like here. Nearly every single-family home sits in a developer-driven, master-planned subdivision in ZIPs 75033, 75034, or 75035, which means the HOA architectural review is a real gate on the timeline – not a formality. Before we order a single panel, we confirm the approved height, coating color, and gate style for your community, and we prepare submittal paperwork that matches what the board is expecting. That’s how you avoid a violation notice a month after install.
The other Frisco-specific factor is the soil. North Texas blackland clay expands and contracts hard with wet-dry cycles, and on Frisco’s slab-on-grade lots that movement can heave a poorly set post out of plumb within a couple of seasons. We set posts deep with proper concrete, and we brace terminal posts at corners and gates so the fence stays true. On a recent repair in a 75035 subdivision, the original installer had set line posts too shallow and the clay had lifted half the run; re-setting the terminal posts and re-stretching the fabric fixed it without tearing the whole fence out.
Hail and high wind are the other recurring pattern. Fences in Frisco take hits that knock fabric loose or bend top rail, and when that happens we match the existing panels and posts as closely as we can so the repair reads as part of the original fence, not a patch. If a replacement is part of a larger rebuild, that work runs through Fence Installation in Frisco, and we’re glad to fold it into one scope across Frisco and the surrounding communities.
Serving Frisco, TX – Our Local Coverage Area
We serve Frisco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Chain Link Fence in Frisco

Most Frisco chain link jobs take two to three working days on site once the HOA review is approved and the utility locates are cleared. The install itself is fast; the HOA architectural review and the 811 locate are what stretch the calendar. Call (844) 560-4467 and we’ll map out a realistic timeline for your lot.
You need HOA architectural review approval for almost any fence in a Frisco subdivision, and the city may require a permit depending on height and location on the lot. We prepare the submittal packet and confirm what’s required before we order materials. Call (844) 560-4467 to start the paperwork conversation.
Yes. If the posts are sound, we can replace damaged fabric, top rail, or a single gate and re-stretch the line to match the rest of the fence. When a terminal post has failed, we reset that post and rebuild out from it. Call (844) 560-4467 for an on-site look at what can be saved.
Residential chain link in Frisco runs $3,500 – $9,000 depending on linear feet, height, coating, and gate count. A 4-foot galvanized side-yard enclosure sits near the bottom; a 6-foot vinyl-coated perimeter with two gates sits near the top. Call (844) 560-4467 for an exact quote – estimates are free.
Every chain link fence we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship on the install, and our technicians have up to 12 years of experience setting posts in Frisco’s clay soil. Call (844) 560-4467 with any warranty question.
Get a free chain link fence estimate in Frisco
Call (844) 560-4467 for a free on-site estimate on your chain link fence in Frisco. A live person answers around the clock, so you’re never stuck in voicemail. We walk the property, confirm HOA requirements, measure the run, and hand you a line-item written quote – no pressure, no surprise numbers. If the fence ties into a bigger exterior plan, we can fold in ADU Site Prep & Utilities in Frisco or a door refresh into the same scope. Call today and let’s get your fence on the calendar.
Written by the team at Groundwork Construction Co.












