







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Irving, TX: What They Cost and How Long They Take
Paver driveways in Irving, TX typically run $7,000 – $18,000 for a residential driveway and take 4 – 7 working days from demo to final compaction. The wide range comes down to square footage, base depth, and paver grade, not sales tactics. Most of the older slab homes along the 183 corridor need more base work than homeowners expect because the black clay underneath has been moving for sixty years. Call (844) 560-4467 for a free on-site measurement and a written line-item quote.
How We Build a Paver Driveway, Stage by Stage

Every paver driveway follows the same sequence because skipping a stage is how driveways fail in five years. Here’s what actually happens on your property.
Stage 1: Layout, Demo, and Haul-Off (Days 1 – 2)
We mark the finished grade with string lines and confirm slope away from the garage before anything gets torn out. Then the existing surface comes up – concrete, asphalt, or old pavers – and the debris goes into a dumpster on-site, not a pile in your side yard. Homeowners decide at this stage whether to widen the apron or add a flare where the driveway meets the street, because doing it later means re-cutting base.
Stage 2: Excavation and Subgrade Prep (Days 2 – 3)
We excavate 8 – 10 inches for a standard driveway, deeper if the subgrade is soft clay. Here in Irving, that soft clay is common. We proof-roll the subgrade with a plate compactor and look for pumping or rutting. If we find it, we talk to you before adding anything. Undercutting the base is the single biggest cost driver nobody warns homeowners about.
Stage 3: Base and Drainage (Days 3 – 4)
A compacted crushed-stone base goes in at 4 – 6 inches in lifts, each one watered and compacted. We install edge restraint at this stage, and we adjust drainage so water exits the driveway toward the street or a specified swale, never toward the foundation. On expansive clay, drainage correction isn’t a luxury – it’s the difference between a driveway that sits flat and one that heaves every spring.
Stage 4: Paver Installation and Cutting (Days 4 – 6)
Pavers go down from a locked edge, in the pattern you chose, with a 1/8-inch joint. Edge cuts are made with a wet saw for clean lines at the apron and garage entry. This is the stage where the driveway starts looking like a driveway. You’ll walk the layout with us before the sand goes in.
Stage 5: Polymeric Sand, Compaction, and Final Walk (Day 6 – 7)
We sweep polymeric sand into the joints, mist it, and compact the field one last time. Final walk-through happens on a dry surface so you can see joint lines and slope. If anything’s off, we fix it before we take a dime for the final draw. Every paver driveway we install carries our 730-Day Done Right Promise – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Before we order material, you’ll make five real decisions. Here’s the honest trade-off on each.
- Paver material: Concrete pavers (Belgard, for one) cost less per square foot and hold color well for 15 – 20 years. Clay brick pavers cost more upfront but patina instead of fading and suit the post-war brick-veneer homes south of 183. Choose based on how long you plan to stay.
- Base depth: 4 inches is the minimum; 6 inches is what we recommend on Irving’s expansive clay. The extra $400 – $900 on base is the cheapest insurance you’ll ever buy.
- Pattern: Running bond is the most economical and fastest to lay. Herringbone costs 10 – 15% more in labor but resists shifting under tire load better.
- Color and finish: Tumbled finishes hide tire marks and small chips; smooth finishes show them. If your garage faces west and takes afternoon sun, darker pavers will read 15 – 20 degrees hotter underfoot in July.
- Edge restraint: Concrete curb is stronger and longer-lasting than plastic edge; plastic edge is fine for low-traffic walkways but not for a driveway taking two vehicles.
What Paver Driveways Cost in Irving, TX

Paver driveway installation in Irving runs $7,000 – $18,000 for a typical two-car residential driveway. That’s the range we quote most often, and it’s a real number, not a teaser.
| Line Item | Typical Range |
|---|---|
| Demo and haul-off | $800 – $2,000 |
| Excavation and base prep | $1,500 – $4,500 |
| Pavers (material + labor) | $3,500 – $9,000 |
| Edging, sand, and compaction | $600 – $1,400 |
| Drainage correction (if needed) | $500 – $2,500 |
Five variables push a job from the low end to the high end: driveway size (a 400-square-foot driveway and an 800-square-foot driveway are two different budgets), existing surface condition (thick old concrete costs more to break and haul), base depth required, paver grade and pattern, and whether drainage needs correcting. If you’re pairing the driveway with a walkway or patio, it’s worth reading up on Driveway & Pavers in Irving before you commit to a scope. Every written estimate we hand you is line-itemed, so you can see exactly where every dollar goes. No change orders without your sign-off, and pricing is upfront – no surprises.
See the difference
Before
After
Before
After
Before
AfterWhat Irving Homes Specifically Do to This Job
Irving’s two construction worlds change how we build a paver driveway. In the older core – 75060, 75061, 75062 – you’ll find 1950s and 60s slab homes where the original concrete driveway was poured to 4 inches with no base to speak of. Those driveways sit on black clay that swells and shrinks with every rain cycle. We routinely pull up concrete that’s heaved a full inch at the garage apron. On those jobs, we spec a deeper base and a drainage correction because the clay will do the same thing to pavers if we don’t. In Valley Ranch and Las Colinas (75038, 75039), we’re working newer planned-community homes governed by HOA design review, which means paver color, pattern, and even driveway width have to go through architectural approval before we order material. We know the drill and we build into the timeline. Need the work done for a neighborhood covered by Irving service standards, and want it done right the first time – that’s what we’re here for.
Serving Irving, TX – Our Local Coverage Area
We serve Irving and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Irving

Most paver driveways in Irving take 4 – 7 working days from demo to final compaction. A 400-square-foot driveway with a solid existing base can be done in 4; an 800-square-foot driveway with drainage correction pushes toward 6 or 7. We schedule around DFW summer heat and spring hail. Call (844) 560-4467 to put a date on the calendar.
Replacement in-kind usually doesn’t require a building permit, but any change to the curb cut, driveway width, or grading near the right-of-way does. We check with the City of Irving before the job starts and tell you in writing whether a permit is required. Call (844) 560-4467 and we’ll walk your specific address through it.
Only if the concrete is sound, level, and properly crowned – and in older Irving homes, it usually isn’t. We’ll test it on the estimate. If the slab has heaved or cracked from clay movement, we tear it out; overlaying failing concrete just transfers the failure to the pavers within a year or two. Call (844) 560-4467 for an honest on-site call.
Surface prep and base work near Las Colinas land in the same $7,000 – $18,000 range as the rest of Irving, though HOA-approved material lines sometimes push to the higher end. Budget an extra $400 – $900 for the deeper base we recommend on clay-heavy lots. Call (844) 560-4467 for an exact quote – estimates are free.
Every paver driveway we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, with no fine print. That’s one of the longest workmanship guarantees in the residential construction space, and it applies to compaction, joint sand, and edge restraint, not just the pavers themselves. Homeowners often pair this with Door Installation in Irving or Cabinets & Countertops in Irving when they’re refreshing the whole exterior at once. Call (844) 560-4467 to schedule a free estimate, or explore our Driveway & Pavers service to see how it fits into a wider project.
Schedule Your Free Paver Driveway Estimate
A free on-site estimate means we measure the actual driveway, check the base, and hand you a written line-item quote – not a phone guess. Our technicians have up to 12 years of experience in this work, arrive in uniform, and are background-checked. Calls are answered by a live person, 24/7. There’s also $1,000 off projects over $10,000 and 0% financing for 18 months if you qualify. Call (844) 560-4467 today.
Written by the team at Groundwork Construction Co.












