







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver driveways in The Colony, TX run $7,000 to $18,000 for most residential installations, and a typical job takes five to eight working days from demolition to the final swept joint. That range covers tear-out of the old surface, a compacted crushed-stone base, a geotextile layer over our clay soils, and the pavers themselves. Call (844) 560-4467 and we’ll walk your driveway and put real numbers in writing.
Why paver driveways in The Colony need a base built for clay, not a base built for sand
The Colony sits on the south shore of Lewisville Lake on expansive clay, and that single fact drives most of the failures we get called out to inspect. A paver driveway poured over a thin base on this soil heaves in a wet spring, settles in a dry August, and by year three you have rutting at the apron and a ripple running down the middle. So we build for movement before we lay the first stone.
Here’s how the work actually runs.
Stage 1: Site walk and layout (day 1, about 2 hours)
We mark the new driveway footprint against your garage apron, your sidewalk and the property line, then confirm slopes so water runs to the street or a swale instead of pooling against the slab. You decide the paving pattern and whether the edges get soldier course or a single running bond. This is also when we check whether your existing concrete is thick enough to leave in place as a base or has to come out entirely.
Stage 2: Demolition and excavation (days 1 – 2)
The old surface comes out, and we dig down far enough to fit a base that will actually hold. That’s usually 6 to 8 inches of compacted crushed stone on a driveway that takes full vehicle loads, more where the old slab sat on fill. Hauling debris off-site is part of the day-two work, and it’s why you’ll see a dumpster in the drive for a couple of days.
Stage 3: Base, compaction and geotextile (days 2 – 3)
We lay a separation fabric, then bring in the stone in lifts and compact each lift with a plate compactor. We test the grade again at this stage, because once the pavers go down the base is sealed in. On The Colony’s clay this is the step that decides whether the driveway is flat in five years.
Stage 4: Setting the pavers (days 3 – 5)
Pavers go down over a screeded bedding layer, cut for curves, aprons and any obstacle like a cleanout or a downspout. Expect a full day of cutting and fitting on a standard two-car driveway; more if you’ve chosen a pattern with a lot of angled pieces.
Stage 5: Edge restraint, joint sand and cleanup (days 5 – 7)
Edge restraints get pinned, joint sand goes in and gets vibrated down into the gaps, and we run a final pass over your lawn and sidewalk to sweep up the dust. You get a walkthrough at the end and a written record of what was installed.
The options you’ll actually choose between

Every homeowner picks their way through this list, and each choice moves the price and the maintenance calendar:
- Concrete pavers (the standard choice). Belgard and Tremron both make a solid line here, and this is what most The Colony driveways get. Long life, holds color, repairable if a single stone cracks. Costs more upfront than pouring concrete, but you never re-pour the whole thing.
- Clay brick pavers. Warmer look, harder surface, more expensive and slower to install. Fits brick-veneer ranch homes well; a poor match for some of the newer two-story styles.
- Permeable pavers. Gaps between units let water drain through the base instead of running to the street. Worth considering where your driveway drains toward the house or where the lot has poor runoff.
- Pattern: running bond versus herringbone. Running bond is faster and cheaper. Herringbone and basketweave interlock better under turning tires, which matters on a driveway more than a patio, and add roughly 10 to 15 percent to the labor line.
- Edge treatment. A soldier course around the perimeter looks finished and pins the field in place. It also adds square footage to the material order.
- Color and finish. Standard gray or tan runs lowest. Tumbled or blended-color faces cost more and hide tire marks better over time.
If you’re also redoing the walkway from the drive to the front door, it makes sense to run it as one project under our driveway & pavers service so the base work and the crew mobilization happen once.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What Paver Driveways cost in The Colony, TX
Most paver driveways in The Colony land between $7,000 and $18,000. Here’s where that number comes from:
| Line item | Typical range |
|---|---|
| Paver driveway installation (standard two-car) | $7,000 – $18,000 |
| Driveway replacement (tear-out plus rebuild) | $5,000 – $14,000 |
| Driveway sealing (after install cures) | $250 – $700 |
Five things push a job toward the high end:
- Square footage and access. A long driveway to a detached garage means more material and more cuts. Tight lots slow hauling.
- Old surface condition. Thick, reinforced concrete takes more equipment and time to break out than a cracked asphalt pad.
- Base depth. If we hit fill soil or old tree roots under the drive, we dig deeper and bring in more stone. Clay is forgiving of nothing.
- Material grade and pattern. Herringbone, clay brick and premium blends all cost more than a standard running-bond concrete paver.
- What needs relocating. Moving a downspout is cheap. Re-routing an irrigation main or a gas stub in the drive path is not.
Your written estimate lists the square footage, the paver line and color, base depth, edge restraints, hauling and cleanup. What it won’t include unless we flag it: irrigation repair if a head sits in the way, and any grading change beyond the driveway footprint. Upfront pricing means the number on that sheet is the number you pay, and the work is backed by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat The Colony homes specifically do to this job

The Colony is fully built out and landlocked, so there are almost no new lots left here. Nearly every paver job we run is a rebuild of a driveway on a home that went up between the 1970s and 1990s. Those driveways have had a few decades of North Texas sun and hail, and many were poured thin over whatever fill was on the lot. We see the same three failures over and over: cracked slabs with a settled middle, drainage that runs back toward the garage instead of the street, and roots from the live oaks pushing under the apron.
The clay under these neighborhoods moves with the seasons, so we spec a deeper base here than we would on sand. Lake-adjacent streets also hold moisture longer after rain, which makes compaction testing worth every minute. If you’re rebuilding, expect to cover the driveway as a line item in a broader plan – homeowners often pair this with a new front entry through Door Installation in The Colony, since the sidewalk and drive meet at the same spot.
We work across The Colony and the surrounding lake communities, and if you’re rethinking the whole front of the house, this driveway work is usually one piece of a Driveway & Pavers in The Colony project.
Serving The Colony, TX – Our Local Coverage Area
We serve The Colony and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Paver Driveways in The Colony
Plan on five to eight working days for a standard two-car driveway, with seven being typical. Weather is the wildcard – a rain day costs you a day because the base has to dry before pavers go down. Scheduling happens about two to three weeks out during the spring build season.
Most residential driveway surface replacements don’t require a building permit, but the rules depend on whether you’re changing the footprint or the drainage. We check with the city before we start and handle any permit needed as part of the job, so you’re not the one making phone calls. Call (844) 560-4467 for a free estimate and we’ll tell you exactly what your project needs.
Only if the slab is sound, level and has the height to spare. On most The Colony driveways from the 1980s, the concrete has already cracked or settled, so tearing it out gives you a better driveway. We’ll tell you honestly at the walkthrough which one your slab supports.
Most jobs run $7,000 to $18,000, with the biggest variables being square footage, base depth and paver selection. A full replacement including tear-out sits in the middle of that range; a larger driveway with herringbone clay brick lands at the top. Call (844) 560-4467 for an exact quote – estimates are free and come with 0% financing for 18 months plus $1,000 off projects over $10,000.
Every driveway we install carries the 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship on the base, the setting and the edge restraint. The paver manufacturer’s warranty on the stone itself runs separately and we hand you the paperwork at the final walkthrough. Estimates are free, so call (844) 560-4467 to get yours scheduled.
Get a free paver driveway estimate in The Colony

We’ll come out, walk the existing drive, check the base and the drainage, and put a line-item estimate in your hands – square footage, paver brand and color, base depth, price. No pressure, no vague ranges. Our technicians have up to 12 years of experience and arrive background-checked and in uniform. Call (844) 560-4467 for a free on-site estimate and design consult, and we’ll get you scheduled.
Written by the team at Groundwork Construction Co.












