







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Addison, TX: What the Job Actually Takes
Door installation in Addison, TX usually runs $1,200 to $4,800 per opening depending on door type, frame condition and whether the rough opening has to be rebuilt, and most single-door jobs finish in one to two days once materials are on site. Exterior doors in this part of North Texas take more abuse than interior ones, so the spec matters more than the speed. Call (844) 560-4467 for a free on-site estimate and a written, line-item quote before anything is ordered.
Addison is a small city with very little new residential construction, which shapes this work in a specific way: we’re almost always fitting a door into a wall that already exists and has been through a few decades of Texas weather, not cutting into fresh framing.
How a Door Installation Comes Together, Stage by Stage

Five stages, and you’ll make a decision at each one. Knowing the sequence up front is the difference between a smooth two-day job and a week of surprises.
1. Measure and opening assessment (day 1, about 90 minutes)
We pull the actual dimensions of the rough opening, check the wall for plumb and square, and look at what’s behind the trim: rotted sheathing, old shims, settled framing, or a previous door installed out of level. This is where we find out whether the job is a straight swap or a reframe. You decide nothing yet; this stage produces the number.
2. Product selection and ordering (day 1, then a lead time)
You choose the door, the material, the finish and the hardware, and we confirm which options fit the opening and the exposure the wall gets. This is the longest leg of the schedule because most doors are ordered, not pulled off a shelf. Standard sizes move faster than custom; we’ll tell you the lead time in writing before you commit.
3. Demo and prep (day 2 morning, 3 to 4 hours)
The old door and frame come out, and we inspect the opening for water damage, insect activity and rot. Anything soft gets cut back and replaced before the new unit goes in. Skipping this step is the most common reason a door leaks two years later, so we don’t skip it.
4. Installation and sealing (day 2, 4 to 6 hours)
The new door goes in, gets shimmed and plumbed, and the perimeter is flashed and sealed. Weather sealing is where a door either holds up to a North Texas spring storm or fails at it. You decide the threshold and the hardware finish at this stage if you haven’t already.
5. Trim, hardware and walkthrough (day 2 or day 3, 2 to 3 hours)
Interior and exterior trim go back on, the lockset and any reinforcements are set, and we test the swing, the latch and the seal. Then we walk it with you before we leave.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Door installation is a spec decision as much as a labor decision. Here’s what moves the outcome:
- Material: steel, fiberglass or solid wood. Steel is the budget option and dents; fiberglass holds paint better and resists warping in heat, and it’s the sweet spot for most Addison exterior doors. Solid wood looks the part but needs maintenance in this climate.
- Door type: entry, patio, storm or security. Each has its own installation constraints and its own hardware set.
- Frame condition: swap into the existing frame or reframe the opening. Reframing adds labor and material, but a door hung in a bad frame will never seal right.
- Hardware and reinforcement: locksets, deadbolts, strike plates and hinge screws. On an exterior door, the strike side is where wind and forced entry both start, so it’s worth specifying.
- Finish: factory finish versus on-site paint or stain, and it affects how soon you can use the door.
What Door Installation Costs in Addison, TX

Plan on $1,200 to $4,800 per door installed, all-in, with the low end being a standard interior or basic exterior swap and the high end being an impact-rated or custom exterior unit with a reframed opening. Here’s roughly how the line items break out:
| Line item | Typical range |
|---|---|
| Standard interior door, installed | $400 – $1,200 |
| Basic exterior entry door, installed | $1,200 – $2,600 |
| Fiberglass or steel exterior with reinforcement | $1,800 – $3,600 |
| Reframe or rough-opening rebuild | $400 – $1,500 |
| Storm or impact-rated exterior unit | $2,500 – $6,000 |
What pushes a job to the high end: an opening that’s out of square or rotted behind the trim, a custom size, a move from a standard to an impact-rated unit, hardware upgrades, and any permit or inspection the city requires for the scope. What typically isn’t in the base number: painting or staining to match existing trim, replacing damaged drywall around the opening, and any structural change to the wall itself.
If the door work is part of a bigger envelope project, it belongs with Windows & Doors in Addison so the sealing and flashing details match across openings. Every project we take on is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Addison Specifically Does to This Job
Addison is a 4.4-square-mile city that’s essentially built out and heavily commercial, dominated by restaurants, hotels, offices and the airport rather than by single-family subdivisions. That means door work here is rarely new construction. It’s almost always going into a wall that’s been there since the 1970s, 1980s or 1990s, often on a building that’s been upfitted more than once. We see the same failure modes every time: frames that have taken decades of summer heat and spring hail, thresholds that have settled, and swing problems that trace back to an earlier remodel that never got the opening square. Because there’s no greenfield to build into, homeowners here tend to renovate the house they have, and the door is usually part of that.
North Texas weather drives the spec. Hailstorms and high winds are the reason an exterior door should be selected and reinforced for wind, not just for looks, and summer heat is hard on any door that isn’t rated for it. We schedule exterior work around the heat and the storm season, and we build the seal and the reinforcement into the job from the start.
We cover the whole Addison area, including the 75001 ZIP, and the surrounding cities of Carrollton, Farmers Branch, University Park and Richardson. For a wider scope, our Windows & Doors service covers the full envelope.
Serving Addison, TX – Our Local Coverage Area
We serve Addison and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Door Installation in Addison

Most single-door installations take one to two days on site, with the bulk of the work done in a single visit. Ordering the door is the long lead, so the calendar time from estimate to finished install is usually two to four weeks.
A like-for-like door swap generally doesn’t trigger a permit, but a new opening, a structural change, or an impact-rated exterior install may. We confirm the requirement with the city before the job starts, and any required inspection is built into the schedule. Call (844) 560-4467 and we’ll walk you through what your scope needs.
No. Our upfront pricing means the number you see is the number you pay. If we open the wall and find something that wasn’t visible at the estimate, we stop, show you, and price the fix in writing before we proceed. You never get a surprise change order.
In most cases, yes. Door installation is a finish-and-frame job, not a structural one, and the opening is already there. If the wall has to be reframed because it’s out of square or rotted, that’s a documented scope change, not a hidden one, and we’ll confirm it with you before the work begins.
Every door we install is backed by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If the door doesn’t swing, seal or latch the way it should within that window, we come back and make it right. Call (844) 560-4467 to schedule your free estimate. Estimates are free, and there’s no obligation.
Ready to Price Your Door Installation?
We’ll come out, measure the opening, talk through the door and the hardware, and leave you with a written line-item estimate at no cost. Ordering timelines, weather considerations and any permit requirement are all spelled out before you commit. Call (844) 560-4467 to schedule your free on-site estimate for door installation in Addison. A live person answers, any hour of the day. Homeowners often pair this work with Cabinets & Countertops in Addison when the adjacent room is getting touched, or with a Garage Conversion ADU in Addison when a new living space needs its own entry. One contractor, one schedule, one point of accountability.
Written by the team at Groundwork Construction Co.












