







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Highland Park, TX: What the Job Actually Involves
Door installation in Highland Park, TX usually runs $1,200 to $6,500 per door depending on size, material, and whether the frame has to be rebuilt, and a typical exterior door is set, flashed, and trimmed in one to two days. The work is more than hanging a slab. In a town built mostly before 1940, it means cutting into a wall that’s settled on black-clay soil, squaring a rough opening that’s racked out of plumb, and making sure the thing survives a North Texas hail storm. Call (844) 560-4467 for a free on-site estimate.
How we install a door here, start to finish

Every door we install runs through the same five stages. The durations are real, not marketing estimates.
Stage 1: Measure and open up (half a day). We pull the interior casing and exterior trim to see the true rough opening. On Highland Park homes this step routinely turns up surprises: rotted sill plates, old termite damage, or a lintel that’s been carrying more load than it should. You decide nothing here except whether to proceed once we’ve photographed what we found.
Stage 2: Demo and prep (half to one day). The old door and frame come out, and the opening gets checked for plumb, level, and square. If the wall has moved, we reframe the opening rather than shim a crooked door into a crooked hole. That’s the difference between a door that closes smoothly for ten years and one that drags by August.
Stage 3: Set, shim, and flash (one day). The new unit goes in, gets shimmed at the hinge and lock points, and the exterior gets flashed and sealed against wind-driven rain. This is the stage that decides whether your wall stays dry during a spring storm. You’ll want to confirm your exterior color and hardware finish before this day, not during it.
Stage 4: Insulate, trim, and finish (one day). We insulate the gap around the frame, reinstall or replace casing, and prep for paint or stain. On an interior door, this is also when the jamb extension gets fitted to the actual wall thickness, which on a 1920s house is never the standard size.
Stage 5: Hardware, adjustment, and walkthrough (half a day). Hinges, lockset, deadbolt, threshold, and weatherstripping get installed and adjusted. We open and close the door a dozen times, check the reveal along the jamb, and walk you through the operation before we pack up.
Five stages, roughly three to five working days per door. If you’re doing several at once, the framing and setting stages compress because we’re already set up.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The decisions you’ll actually make
Most of the buying conversation is about three things: the material, the core, and the hardware. Here’s how the choices shake out.
- Fiberglass vs. steel vs. wood. Fiberglass won’t dent and handles North Texas hail well, but it costs more and some styles can’t be matched exactly. Steel is the budget-friendly exterior choice but dents and eventually rusts at the bottom edge. Wood gives you real character and is what most Highland Park homes originally had, but it needs paint every few years and it moves with the humidity.
- Solid core vs. hollow core (interior). A hollow-core door sounds cheap when it closes and does nothing for sound. A solid-core door feels like a door, dampens noise between rooms, and costs roughly double. For bedrooms and bathrooms in this market, solid core is the sensible call.
- Wind-rated units. North Texas building departments care about design pressure ratings on exterior doors. A properly rated, impact-rated unit resists both wind load and hail, and it’s the single biggest factor in whether an exterior door survives a bad storm.
- Hardware and finish. A cheap lockset fails first. A good deadbolt and a properly hung hinge set cost $80 to $300 and prevent the most common callbacks.
- Configuration. Single, double, sidelit, or a transom above. Every extra panel adds cost and, in a wall with mature trees nearby, changes what you’re allowed to cut.
If this door is one piece of a larger exterior refresh, it fits naturally into our Windows & Doors work. Homeowners often pair this with Cabinets & Countertops in Highland Park once an interior wall shifts and the kitchen footprint opens up.
What Door Installation costs in Highland Park, TX

Exterior door installation in Highland Park generally lands between $1,200 and $6,500 per door installed, and interior doors typically run $400 to $1,800 each. Those numbers include the door, the labor, the flashing, and the finish carpentry around it.
Five things push a job toward the high end:
- Frame condition. A sound rough opening is a simple install. A rotted or racked frame forces reframing and adds $400 to $1,200.
- Wall material. Brick veneer takes longer to cut and patch than siding and costs more to restore.
- Door size and configuration. A standard 36-inch single is the low end. A double door with sidelights or a transom can triple the material cost.
- Rating and glass. Impact-rated units and decorative glass add real money, but they’re what a North Texas exterior needs.
- Permit scope. If the opening changes and a structural header is involved, the permit and inspection cycle adds time and usually $150 to $600.
A written estimate from us itemizes the door model, the frame prep, the flashing, the trim, and the hardware. What it won’t include unless you ask: paint or stain of the finished door, interior drywall repair beyond a small patch, and anything structural we can’t see until the wall is open. We tell you that upfront rather than handing you a change order on day two.
See the difference
Before
After
Before
After
Before
AfterWhat Highland Park homes specifically do to this job
Highland Park is a nearly built-out town, and almost every project here is a renovation, an addition, or a rebuild rather than new construction. That changes door installation in a practical way. The town has its own building inspection department, separate from Dallas, plus design-review and Historical Review Board approvals, so a door that changes the exterior appearance may need sign-off before we cut anything. Contractors here also thread tree-protection rules for protected live oaks, and a job can stall on a root zone before it starts.
The housing stock dates mostly from the 1910s through the 1930s: Tudor, Colonial, Mediterranean, and Prairie-style homes with original single-pane wood units and pier-and-beam foundations. We routinely open a wall and find knob-and-tube wiring and a framing layout that predates the door we’re replacing. If the new opening gets cut and our Highland Park team is already on site, we cover the whole block of work under one estimate. And for a detached structure or an addition where a new exterior door is part of a bigger plan, this is often paired with a Garage Conversion ADU in Highland Park so the door aligns with the new build.
The failure modes we see most: settled sills that let in water after a wet-dry clay cycle, doors that won’t latch because the jambs have spread, and old wood units that have lost their seal and leak air against the summer heat. All three are fixable. All three get worse if you wait through another spring.
Serving Highland Park, TX – Our Local Coverage Area
We serve Highland Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked about Door Installation in Highland Park

A single exterior door takes one to two days once we’re on site, and an interior door is usually a same-day install. The full schedule from measurement to walkthrough is roughly three to five working days per door, longer if the town’s inspection cycle is involved. Call (844) 560-4467 to get a real timeline for your door.
You need a permit when the rough opening changes, when a structural header is involved, or when the exterior appearance changes on a home subject to design review. A straight replacement of the same size in the same opening usually doesn’t require one. We pull the permits and pass the inspections on any job that needs them, and we’ll tell you upfront whether your door falls on that side of the line. Call (844) 560-4467 for a straight answer on your specific door.
Yes, in the large majority of cases. If we’re replacing a door in the same opening, there’s no need to touch plumbing or structural framing. The complication is when a wall has settled on Highland Park’s black-clay soil and the opening is out of square; then we reframe the opening itself, which is carpentry, not plumbers or engineers.
Exterior door installation typically runs $1,200 to $6,500 per door installed, and interior doors $400 to $1,800 each. The variable that moves the number most is frame condition and whether the opening has to be rebuilt. Call (844) 560-4467 for a written line-item estimate; the quote is free and the pricing is set upfront.
Every install is backed by our 730-Day Done Right Promise. If the door doesn’t close right, if the flashing leaks, or if the trim pulls away, we come back and make it right for two years after we finish. The door manufacturer’s warranty covers the unit itself on top of that. Call (844) 560-4467 for the full written terms.
Get a free on-site estimate for your Door Installation
We’ll come out to your Highland Park home, measure the opening, check the frame, and hand you a written estimate with the number you’ll actually pay. A live person answers our line 24 hours a day, so call whenever it’s convenient. Estimates are free, financing is available at 0% for 18 months, and there’s $1,000 off projects over $10,000. Call (844) 560-4467 to schedule.
Written by the team at Groundwork Construction Co.












